Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinctly SUV-like feel due to its larger dimensions. Moreover, the 19-inch wheels on Ti and ST-L models may be a bit stiff at times. The front tyres of Qashqai could also lose traction on rough surfaces, and its CVT can occasionally display wrist-flexing torque steering.

This is usually due to a dead coin battery which can be repaired in a matter of minutes. Make sure that the replacement battery has the same voltage, size, and specification.

Water Damage

Water damage is among the most frequent causes for the Nissan keyfob to display the "key ID is wrong" message. The key fob comes with rubber seals which protect the chip inside. However, prolonged exposure to moisture can cause it to cease functioning properly. It is common to observe this happen if your key fob was dropped into the water or in a swimming pool. However, it can occur when it is wet due to showers or soapy hands.

If your key fob has been exposed to water over many years it is possible to clean it with isopropyl, or an electronic cleaner. In addition, it may require a visit to an expert for repair or replacement.

If your key fob has to be replaced, it's an easy process. First, ensure you have a multipack of the correct battery (CR2032 3V). Then open the front and back cases with the small flathead screwdriver. Remove the metal clips, take out the battery, and then replace it. After reassembling the fob, put the mechanical key back in its place and make sure it functions as intended. If it does not then you'll need to go to your local Nissan dealer or an expert auto locksmith to fix the key chip. The chip is typically not damaged by water, so it isn't too costly.

Dead Coin Battery

Another reason why the reason your Nissan Qashqai key fob might not function is that the coin battery has gone dead. These batteries usually last 3-5 years, but they can become depleted over time, especially when the fob is frequently dropped. You can replace the battery, however, make sure it's the same voltage and same size as the first. If you're using an alternative battery, it could cause the key to have an untrue key ID, that could hinder it from pairing with your vehicle.

The most efficient method to change the coin battery in the nissan qashqai key replacement price Qashqai Key Fob is to open it with a small flat-head screwdriver. The screwdriver needs to be inserted into a small notch on the bottom of your key fob. The screwdriver should be gently twisted to split the two halves. Then, take out the old CR2025 button cell battery and insert the new one after confirming its location in the fob.

Check the terminals for any water damage or dirt before installing the new battery. If there is, clean the terminals with a small amount of isopropyl alcohol. Make sure that the pole cables are properly connected. They should be connected to both the positive and negative poles of your battery.

Fault Diagnosis

If your Nissan Qashqai key fob stops working after exposure to pure tap water or rain, it may be an indication of a chip issue inside. You'll need a new keyfob if you are unable to fix the issue by changing the battery. If you dropped the key fob on the ground and it stopped working instantly it's likely because it has damaged the internal chip. You can usually get the key fob to function again if you take it out and clean the chip using paper towel and isopropyl alcohol before putting it back into.

A common error that you may see on your dashboard is "Key ID Not Correct." This means that the car is unable to recognize the key fob and will not allow it to start the engine. The problem can be caused by many things like water damage, undetectable issues in the key fob's circuitry or RFID interference.

The key fob won't work when the 12 volt batteries are dead or fail to provide enough electrical current. This will affect the remote keyless system as well as central locking on your Nissan Qashqai, as well as hindering you from starting the engine with the key fob (if equipped with Intelligent Key). Check the battery in the key fob in case you are not able to lock or unlock your door manually. Try reconnecting the battery in order to reset your transmitter.

Reprogramming

If the key fob is not been submerged in salt water and is unable to come back to life after a simple wash with clean water. You can also try cleaning the electronic chip using isopropyl Alcohol or an electronic cleaner. If none of these works then you might need to replace the key fob.

If your Nissan Intelligent Key still does not work, it could be a connection issue between it and the vehicle. To relink it, start by turning the key in the ignition without starting the car key replacement nissan. Keep doing this until you see the hazard lights flash twice. Then, turn off the vehicle and take off the key.

Then, you need to open the fob compartment in your vehicle. It's usually found on a door jamb or the handle of the driver's door. Find the small button labeled "program" and press it. When the process is complete you will hear a chime.

Now that your Intelligent Key is relinked to the car key replacement nissan is the time to test it out. Set your feet a distance from the vehicle, and hit all the buttons on it. If the lights flash and the horn sound it means the key has been successfully linked to the Nissan. You may also try testing it close to the nissan qashqai Spare Key.